dalek showcase: our members daleks dislpayed

 

AdamSt: 1960s Dalek

Alansdalek: Maxx

American Dave's Dalek build

John and his original Project Dalek build

Mike Bull's Dalek Rosco

Shytalk's Albert. A New Series Dalek in black

Simon Morrell's NSD Attila

Spagga's Genesis Dalek: Darling

Steve & Liam's amazing NSD

Subcusick's 1980s Renegade Dalek

Thaspy's Genie a brilliant Genesis Dalek

Zeked's Genesis Dalek, mean and menacing

 

forum members click here for access to the comlpete build diary

 

Back to the Project Dalek front page

Thalspy: Genie


Thalspy's Genie is a radio-controlled, motorised build using a Futaba Skysport 6 transmitter with Roboteq AX2550 motor controller. Thalspy says, "pictures don't really do her justice as she's at her best when in motion". You can see a video of the her in action here.

Based on a 1970s 'Genesis' Dalek, Genie has many features which are authentic to that era. Particular attention has been paid to the details such as the size of the gap between the dome and upper neck ring and the slightly bent gun rods, which are quite correct, but rarely replicated by builders.

Genie the Dalek finished and ready for work!

How it was done

Dalek neck bin and eye-stalk servo units etc.
Here is an early shot of the neck bin with eyestalk assembly. You can see the servo motor and gearbox. It is a 'hacked' Futaba servo (made to run continuously) and hobby-type gearbox. The assembly is linked to the stalk via a control rod similar to those used to control model-aeroplane elevators.
Dalek motors inside the neck bin.
Dome rotation is controlled by a 12V electric screwdriver motor that is controlled by a 12v bi-directional speed controller. A second Futaba servo (in normal operation) operates the potentiometer to the speed controller. The motor sits just below the top of the neck bin.
The motorized Dalek base.
It took about four months to design and build the motorised base section and cost about £1000. The chassis was made from 1" box section steel and 0.5" box section steel for the cross members.
Dalek base showing internal motors and gears etc.
10" Dunlop wets on hubbed front Go-Kart rims. Casters: pneumatic 6" front and rear. Motors and gearing: 2x Bosch 750W through custom gears to go-kart chains and sprockets. Axles and bearings: go-kart front axle (halved) with pillow blocks and go-kart axle bearings..
Motorised Dalek base with surround and seat attached.
Motor Controller: programmable Roboteq AX2550 with RC input. Batteries: 2x 12v Odyssey PC545s. Additional: Motorsport cut-off switch. Seat: MDF! The entire gear assembly sits on a silver steel shaftwith bearings, thrust bearings and shaft locks, some of which had to be imported from the U.S.A.
Looking down into the Dalek skirt through the open shoulder section.
The Roboteq AX2550 can be connected to a PC for programming the motor's power, deceleration ramps and joystick calibration. It can also be controlled via software, with input from sensors such as motion detectors and infrared, so there are possibilities for a fully autonomous Dalek!